-
Montenegro +382 68 584 699
-
Germany +49 162 874 2423
-
Slovenia +381 611 985 908
-
Serbia, Croatia, Bosnia and Herzegovina +381 611 985 908
Battery box BB2.1x, 2 batteries + 1 inverter
Original price was: 232.41 €.198.94 €Current price is: 198.94 €.
Box for 2 batteries and 1 inverter. 48 V DC. 100 A fuses.
Description
The battery box is designed for the parallel connection of 2 batteries and 1 inverter at a voltage of 48 V DC. The box is equipped with 100 A fuses for individual batteries and 250 A for the output to the inverter. It is well-prepared for the installation of input and output cables thanks to the triple openings on the bottom side of the box. A disconnect switch for DIY installation is included with the box.
Do not turn off or on under load. Interrupting under load will cause contact burning and subsequent damage to the device, which is not covered by warranty. Improper handling poses a risk of transitional resistance and, consequently, fire.
Installation and Connection
- Always work with the device de-energized. Installation of the device may only be performed by a qualified person.
- The device is intended for indoor use at temperatures from +5 to +25 °C and humidity up to 95% non-condensing. Do not place above heat sources, such as inverters.
- The device is designed for mounting on a non-combustible surface in a vertical position so that the cable outputs face downward. This position must be maintained for proper natural ventilation of the device.
- Do not block the ventilation openings or the cable entry points.
- Install and secure cables so that no tension greater than 3 N is applied to the screws.
- Wires are connected using a cable eye with a 10 mm hole.
- Use the correct wire cross-sections for individual branches or install fuses with a lower adequate rating. Fuse type ANL.
- Connect the battery branch (the first 2 branches on the left, 100 A) with a minimum cross-section of 25 mm2.
- Connect the inverter branch (the last branch on the right, 200 A) with a minimum cross-section of 70 mm2.
- The torque for tightening the connecting screws is 12 Nm.
Key Parameters
- Dimensions: 146 x 196 x 88 mm
- Operating voltage: 48 V
- Continuous current through the device: 140 A
- Short-term current: 200 A (max 5 min)
- Peak current: 250 A (15 s)
- Protection degree IP20
Package Contents
- Battery box
- Victron Energy disconnect switch – 48V / 275A
About Brands
About J.K. Switchboards LTD
J.K. Switchboards LTD was founded in 1977 with emphasis in the electromechanical section. Target markets are mostly Cyprus and the Middle East countries, covering mainly the industries of construction, process, telecommunications, banks etc.
Today, J.K.Switchboards LTD is a versatile entity that covers a broad range of activities providing a complete and efficient solutions to the needs of our customers. Company employs a group of professional and expert employees that are ready to provide the best solution for the given requirements.




















